Hi Philippe,
On Wed, 24 Sept 2025 at 03:52, Philippe Simons
<simons.philippe@gmail.com> wrote:
>
>
>
> On Wed, 24 Sept 2025, 00:35 Simon Glass, <sjg@chromium.org> wrote:
>>
>> Hi Philippe,
>>
>> On Tue, 23 Sept 2025 at 16:24, Philippe Simons
>> <simons.philippe@gmail.com> wrote:
>> >
>> > I'm currently trying to bring a SM6115 device on Linux but... without much success...
>> > I have replaced my ABL with qcomm/abl2eps which allows me to boot an efi application.
>> >
>> > I've tried to use ARM64 EFI STUB for that but the resulting u-boot-efi-payload.efi doesn't look like an PE32+ binary....
>> >
>> > file u-boot-payload.efi
>> > u-boot-payload.efi: data
>>
>> Which board are you building here? Is this with the concept tree?
>
>
> Trying to build for the Mangmi AirX handheld, a SM6115. I'm using the concept tree yes.
I'm actually wondering which U-Boot board (defconfig) you are using /
building? If you created something new, can you send a link to your
tree?
Oh, I attached the defconfig to my first post, but maybe it didn't go through...
I basically used the qcom_defconfig, added CONFIG_EFI_CLIENT, CONFIG_EFI_STUB and my device tree.
>
>>
>> >
>> > Could you help me
>>
>> The stub is only partially functional - one of the challenges is that
>> it needs device-specific knowledge, so you must create a stub for your
>> particular SoC. I did fiddle with integrating a bit more stuff into it
>> about a month ago, but it is always going to be SoC-specific.
>
>
> What do you mean by creating a stub for your particular SoC... I understood the STUB is just a EFI PE32+ that copy the real u-boot in memory and jump to it.
> My issue is that the u-boot-payload.efi is not an EFI PE32.. I tracked down the issue with the final objcopy step, which isn't using the --target argument.
> But even when doing that step manually, I couldn't start the resulting .efi
>
>>
>> Have you tried using the app? It is efi-arm_app64_defconfig and is
>> pretty generic so should run on anything with an EFI interface.
>
>
> The EFI app works, in the sense I managed to get it running, but I couldn't get it to boot the kernel using an extlinux.conf file...
> Something with the FDT... But I don't expect this to work any better than just using grub EFI.
Right.
BTW there is a test for booting with extlinux (test_distro_arm_app_extlinux).
Regards,
Simon